buchspektrum Internet-Buchhandlung

Neuerscheinungen 2012

Stand: 2020-01-07
Schnellsuche
ISBN/Stichwort/Autor
Herderstraße 10
10625 Berlin
Tel.: 030 315 714 16
Fax 030 315 714 14
info@buchspektrum.de

Richard Doornbos, Sjir van Loo (Beteiligte)

From scientific instrument to industrial machine


Coping with architectural stress in embedded systems
Ed. by Doornbos, Richard; van Loo, Sjir
2012. 2012. xii, 112 S. 55 SW-Abb., 1 Tabellen, 1 Farbtabellen. 235 mm
Verlag/Jahr: SPRINGER NETHERLANDS 2012
ISBN: 9400741464 (9400741464)
Neue ISBN: 978-9400741461 (9789400741461)

Preis und Lieferzeit: Bitte klicken


Architectural stress is the inability of a system design to respond to new market demands. It is an important yet often concealed issue in high tech systems. In From scientific instrument to industrial machine, we look at the phenomenon of architectural stress in embedded systems in the context of a transmission electron microscope system built by FEI Company. Traditionally, transmission electron microscopes are manually operated scientific instruments, but they also have enormous potential for use in industrial applications. However, this new market has quite different characteristics. There are strong demands for cost-effective analysis, accurate and precise measurements, and ease-of-use. These demands can be translated into new system qualities, e.g. reliability, predictability and high throughput, as well as new functions, e.g. automation of electron microscopic analyses, automated focusing and positioning functions.

From scientific instrument to industrial machine takes a pragmatic approach to the problem of architectural stress. In particular, it describes the outcomes of the Condor project, a joint endeavour by a consortium of industrial and academic partners. In this collaboration an integrated approach was essential to successfully combine various scientific results and show the first steps towards a new direction. System modelling and prototyping were the key techniques to develop better understanding and innovative solutions to the problems associated with architectural stress.

From scientific instruments to industrial machine is targeted mainly at industrial practitioners, in particular system architects and engineers working on high tech systems. It can therefore be read without particular knowledge of electron microscope systems or microscopic applications. The book forms a bridge between academic and applied science, and high tech industrial practice. By showing the approaches and solutions developed for the electron microscope, it is hoped that system designers will gain some insights in how to deal with architectural stress in similar challenges in the high tech industry.
Foreword. Acknowledgements.

Part I Introduction .

1. The Endeavor.

Part II Architecture .

2. Systems Architecture. 3. Feasibility prototyping. 4. Software architecture.

Part III Automation and control functions.

5. Applications in automated microscopy. 6. Focusing control. 7. Positioning control.

Part IV Conclusion .

8. Final words.

Appendix. Condor Project Publications.